Board layout for the radiation sensor electronics.
Schematic for 3 parts of the actual electronics
Operation:
The circuit for this design was originally designed by Eric Gowens. This design was simply implemented on
a breadboard. The goal for this project was to take this design and cast it onto a printed circuit board. This
was done using layout software and the design was set out to be fabricated. The necessary parts were then ordered
and placed on the board. The routing had already been complete during the design stages. Below are a couple of
different pictures that show the basic layout of the board.
Board layout for the radiation sensor electronics.
Schematic for 3 parts of the actual electronics